Skip to content
G2 Capterra Trustpilot

Free calculator

Car soundproofing price calculator

Tick the zones you are treating, pick the car class and the layers (damping only, or damping plus an absorber). The calculator estimates the area, counts sheets with an allowance for trimming, adds your hours and gives the cost, the client price at your margin and a price range.

The numbers in the form are an example. Replace them with your own.

Doors (4)
Floor
Wheel arches
Trunk
Roof
Hood
Firewall (bulkhead)
Car class
Layers
%

Material lost on cutting around clips, holes and curves.

m2

A common sheet is about 0.37 m2 (47 x 75 cm). Take the figure from your supplier.

$
$
%

The panels are already stripped for the damping layer, so the absorber adds a share of the time, not a second job.

$

Cost of a workshop hour. Hours per zone are example norms: replace them with your own timing.

$
%

Share of profit in the price. 40 means 40 of every 100 of price stays as profit, not 40% on top.

Related calculators

How to price a soundproofing job

The price starts with the area. Doors, floor, arches, trunk, roof, hood and firewall each have their own area, and the car class scales it: a compact is smaller, a minivan is much bigger. Add the allowance for trimming, divide by the area of one sheet and you know how many sheets to order.

In the example the area is about 8.2 m2, so 26 sheets. With the absorber layer the materials come to about $187. Labour is 28 h at your hourly rate, about $978. Cost is about $1,180, and at the margin of 40% the client price is about $1,970.

Where the hours go

  • Doors and roof take the longest: trim, headliner and wiring have to come off and go back.
  • The floor means pulling seats and carpet, so it is a big block of time even if the area is simple.
  • Arches and trunk are quicker, but the shape needs a lot of cutting.
  • The absorber layer adds a share of time because the panels are already open.
  • Hours per zone in the calculator are example norms. Put your own from past jobs.

What moves the price most

  • Number of zones: a full job costs several times more than doors only.
  • Layers: damping plus absorber nearly doubles the materials.
  • Car class: a minivan has about a third more area than a sedan.
  • Hours and rate: labour is usually the larger part of the price.
  • Margin: it is counted on the price, not added on the cost.

Common mistakes when quoting

  • Quoting from the average hours and ignoring a car that is hard to strip.
  • Forgetting the allowance for trimming: sheets run out one door short.
  • Mixing up markup and margin.
  • Leaving out consumables: rollers, solvent, clips, tape.
  • The areas here are an estimate. The result is a calculation from your numbers, not a promised price.

In Evimarko the material stock and the master's hours go straight into the order, so you see the profit on every soundproofing job.

Where to next

Questions and answers

How accurate is the area?+

It is an estimate for a typical sedan with a correction by class. Real cars differ, so measure or use your own table when the price matters.

Do I need an absorber layer?+

Damping alone removes panel resonance. The absorber layer works on airborne noise and costs extra materials and time. Compare both options in the calculator and show the client the difference.

What is the range at the bottom for?+

It shows the price if the job takes 15% fewer or 25% more hours than planned. A rusty or already glued car goes into the upper end.

Reviewed and updated · About us